Subject: Ross gear box Needle thrust bearings
From: ACRE NL
Date: 8/23/2001, 7:00 PM

The 1.5" ID 2.187" OD needle thrust bearing has a max RPM of 7700 and
a dynamic load rating of 4250 pounds. The static load rating
is 23,000 pounds so a reduction in speed by using two back to back
should make it more bullet proof.

Dynamic load rating is equal to applied load * SF * LF * HF

LF is a life factor. We will do this later.
SF is the speed factor. Goes from 5.2 at 8000 RPM down to 4.25 at 4000 RPM.
HF is a hardness factor. Anything above HRC 58 is greater than one.
So we will assume this factor is one and drops out.

More on this latter. Lets just see if we can fit two of these in there.

The thickness of this little jewel with out races is .0781.
The thinnest race you can get is .032 so three of these and two
bearing would be a total of .252 inches thick. Not too bad.

Now we need to verify that seal thickness and counter bore depth.
Finn the ball is in your court.

The the 2.75 inch  seal diameter is a problem so perhaps a steel plate in there
between the seal and the thrust bearing like Finn suggested will work.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

finn2.gif