Russell Kent wrote:
Paul Lamar wrote:
The helical gear thrust formula is T = F * TAN(helix angle)
F is the tangential force and T is the thrust in pounds.
The Ford C6 sun gear has pitch diameter of roughly 1.8 inches.
From that you can figure the tangential force given the torque.
The helix angle from eyeball is about either 30 degrees or 60
degrees depending. Probably around 30 degrees.
I think Tracy knows what angle it is exactly.
Tracy Crook replied:
I'm not a math wizz but I thought the formula used the cosine of the helix
angle. I agree that the 1100+ pounds you got does not sanity check. Think I
got around 800 pounds when I calculated it. Somebody out there help us math
challenged types!
Paul Lamar replied:
Speak for yourself :-)
The formula is correct. Don't know where I found the first one
but I confirmed it from Stock Drive Products 1990 Handbook of Gears
page T57.
I think the angle is more like 16 degrees and not 22
(the rise is .5 inches in 1.68 inches) as Finn stated so if that
is the case the thrust load is a more reasonable 764 pounds
which jibes better with your calculations Tracy.
You weenies. :-)
Paul's formula passes the sanity check: at zero helix angle (i.e. straight cut
teeth), the helix thrust should be zero. tan(0) = 0, but also so is sin(0) = 0.
At 90 degrees helix angle (I know, not really a gear), sin(90) = 1, meaning the
*maximum* thrust would be only the force input. But we all should recognize that
the gear mesh is a group of ramps, and that ramps are force multipliers, so the
thrust force should be able to exceed the input torque. Luckily, tan(90) =
infinity.
As for the gear angle, if the rise is truly 0.50 over 1.68, then I think the
formula is:
sin-1(0.50/1.68) = 17.3 degrees
which means Finn's calculated thrust should be about:
2666 * tan(17.3) = 830 pounds
BTW, anyone care to do all that in metric? :-)
I am still not sure of that angle as I don't know how to measure
it accurately yet. I think you need to unscrew it and measure
the angle of rotation as one tooth is completely uncovered.
It could very well be 22 degrees as Finn claims.
If you can accurately meaure the diameter (at the tooth tip) and chord length
(distance between the ends of the tooth as projected onto a plane), I can
calculate for you the angle.
Russell Kent
Good idea Russell. Un wrap it.
Tooth length is 1,72
diameter is 2.08
and gear length is 1.58
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org