Subject: Perry's new prop shaft
From: ACRE NL
Date: 8/24/2001, 2:54 PM


High Charlie,
How is it going?

What bearing did you use on your desgin?

Paul Lamar

Perry is thinking of extending his prop shaft and adding
a ball thrust bearing. This is similar to what Charlie
Airesman did on his direct drive Soob.

Here is my first cut on the the design.
Any criticism or comments?

Paul Lamar

"Charles D. Airesman Jr." wrote:

Paul

I use a sleeve bearing oiled by the engine. That way I do not have to worry
about expansion when things heat up. all of the thrust goes into the engine.
My hub has a much larger cross section and a flats milled on it where the
carbon wraps around it.

The plane is flying great. Burning less than 5 GPH at 220 MPH. I have about
1230 hours on it now. I can not say enough good things about Tracys fuel
injection.

Charlie

That is an incredible 44 mpg. Almost as much as Klause is claiming :-) (52 MPG
at 200 MPH). I think you and Klause need to have a contest where
you both fly side by side for x numbers of hours and see who
burns the least amount of fuel. 

Five gallons per hour is about 30 pounds of fuel
per hour. Divided by .45 BSFC is 66 HP.  Divided by an exceptional BSFC
of .40 that is still only 75 HP for 220 MPH. Wow that is a real 
slick airplane and highly efficient prop you got there Charlie. 
You must be on to something with that long shaft extension.

Did not see you at OSH. Where you there this year?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Charly-airesman-direct-drive-EZ.jpg