Finn Lassen wrote:
Ok, I did it. Now I can't go fly :-(
Thank you Lord!!! PL
Here's how I did it:
With a 1/8" abrasive disc in my hand drill I cut a groove along the
gear, passing next to one of the pins. You don't need to grind all the
way down to the shaft. The gear will split when you get close.
Cut a groove on the other side of the pin. Two more grooves on each side
of the opposite side pin.
Rested teeth of sun gear on a bench vice and tapped on the end of the
shaft (via a metal block to protect the end of the shaft) with a mallet.
Actually, I messed up and cut the long groove through one of the pins.
After pulling out one pin with the vice, I drilled through it's hole to
the other pin and drove it out with a 1/8" pin.
You might wonder why I didn't try to remove the pins first and then
press off the gear.
The shaft under the sun gear mikes to approx 1.4406". Tracy says the sun
gear ID is 1.440". Tracy told me this is an interference fit and might
result in galling the shaft if you try to press it off. Besides, I don't
have a press.
Finn
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org