Finn Lassen wrote:
Ok Paul,
I do read all of your messages, but I'm not sure you're reading all of
mine :)
We're not quite on the same page anymore.
I believe I can add an 180 hour thrust bearing, with practically no
machining.
See attached sketch (not to scale, not all details shown).
1) I don't want to increase the distance between the gear housing and
the bell housing. The gear housing is sitting in a 0.11" recess in the
bell housing - that's how it's centered, not by the circle of bolts.
(The measurements I've given is all from the bottom of that recess, so
forget about the surrounding .11" high and 1/8" wide "lip" that forms
the recess.)
First I have heard about this but it is still not a problem.
The spacer can be machined to retain this piloting feature.
2) The rear of the planet housing fingers rest against the bell housing
bulkhead.
3) There is an 3/16" recess in the rear side of the planet carrier. The
fingers slant down to a 4 1/8" D flat recess. I'll have room for the
1/8" thrust plate in that recess.
4) The ID of the carrier is 2.165"
5) Axial distance from fingers (and bell housing bulkhead) to planet
gears is 0.512".
6) Counter bore for seal in bulkhead stays where it is.
I'll have the sun gear cut to length so that it sticks out past the
planet gears by 0.245". In that .245" area I'll fit the 3/16" pin.
Next to that the thrush bearing and it's race washers: 0.142"
This is followed by the 1/8" thrust plate: 0.125
Total: 0.512"
The only catch: The 1.5" ID bearing with it's 2.187" OD will not fit in
the 2.165" planet carrier ID.
So I either have the input shaft machined down to the next lower size
bearing: 35 mm, or the planet carrier machined out to 2,187 to fit the
1.5" ID bearing. Since Tracy will sell me a good carrier, I'll probably
go with the 1.5" ID bearing.
This leaves the only "machining" I have to do:
1) Cut a 1/8" plate to size.
2) Make a 35 mm or 1.44" hole in it.
3) Drill the 3/16" hole for the pin.
Anyway, it all hinges on 1/8" steel plate being strong enough for the
thrust load.
I'm going to assume it is and go ahead with this, unless you tell me
otherwise.
Finn
We are definitely not on the same page Finn because I refuse to do
this half ass. Worlds first psru engineered with a paint program :-)
Good luck.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org