< snip >
Wow! That looks great Monty. I was just kidding about the under the cowl
renditions and here you have them done.
do you really think I just make this stuff up? ;-)
So cool. You ought to do a article for the
EAA Sport Aviation magazine on this. Judging by the results Charlie
Airesman is getting this thing ought to be real fast.
Won't be long before someone is going 300 MPH with a rotary at this
rate. You got dimensions on the engine so you can do a 3D on that too?
BTW Butch is getting ready to spring the LAEV variable pitch
prop on the world which you will need.
Paul Lamar
Paul,
Not sure I'm ready to do an article yet. I would rather wait until I have
some hardware to show. I really want to make one of these things that has
the minimum drag possible. I want to shoot for the best efficiency I can
get. That definitely calls for a variable pitch prop. I flew a 182 the other
day, which was my first experience with a variable pitch prop. WOW! what a
difference that makes! I knew it made a big difference on paper, but until
you get the seat of the pants feeling for how much difference it makes you
can't fully appreciate it. A canard REALLY needs a variable pitch prop, and
so does an RV for that matter. I could maybe do an article on the theory
behind designing something like this engine installation. There are so many
different angles I'd have to pick one topic and concentrate on it. Cooling
drag reduction for instance. I don't know if it would be better suited for
Contact! or a more technical type mag.
300 mph would be nice {8O. I'm still a little scared about the airframe. Its
quite a bit faster than Burt's published VNE. I'm sure he was conservative,
but I want to know for sure what the airframe is capable of before I try for
those kinds of speeds. The Berkut has a higher VNE, something like 400 mph
if I remember correctly. So I asume that it would be possible to beef up the
spar etc. to make the airframe capable of those speeds. The Memphis gig
would be a good time to sit down and discuss these things in detail. I'm
sure that Herb can set me straight on this.
I'm waiting for a few projects to pan out so I can buy a new piece of
equipment before I model the engine in detail. It is a 3D digitizer that is
good to within about 5 thou. Plenty good for entering the outer shape of the
engine, etc. It sure beats the caliper and enter method, and is much more
accurate to boot. This coupled with an NC mill should make reverse
engineering all too easy :-)
Monty
Klause is going over 250 with a Varieze but he has discovered some things
along the way. I am sure Herb is aware of them. Klause is also very
fond of beefing things up with carbon.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org