Jerry Hey wrote:
I just got the exhaust flange from Mazda Tricks. The ports are
2.120" diameter. This causes a .060 gap around the perimeter of the
two inch o.d. exhaust tubes. Should I ignore this and just weld
across the gap or should I have the end of the tubes expanded for a
tight fit prior to welding. Maybe there is a reason (expansion?)
for the sloppy fit. ---Jerry
I would check with Dave Lemon at Mazdatrix on this Jerry. Find out
what they had in mind.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org