Peter Cowan/Lexi Cameron wrote:
Had the first run today in my rotary boat. Got pretty loud when the rubber hose that connects the engine exhaust manifold to the through-transom pipe slipped off. Also pumps a lot of lake water into the boat when this happens. Because of this I didn't run it very hard but at 4000 rpm it is a lot faster than the old Volvo.
One problem is poor idling. When cool can't get much below 1800; when hot it dies at about 1300. Could the additional back pressure of having to push the exhaust out underwater be the problem?
Water temp is not going above 100 f for some reason.
Peter.
That idle is not high for a rotary but does it clunk when you put it in gear?
Sounds like the back pressure has something to do with it. Why under water.
Noise? How far under water?
We would love to see a bunch of pictures Peter.
Sure that is not 100 C ? Can you put your hand on the top of the rotor housing?
Sneak up on it. Don't burn yourself :-)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org