Subject: chrome plating the rotor faces?
From: ACRE NL
Date: 8/31/2001, 5:08 PM


 > > > >Have any of you rotary car racer types tried chrome plating
 > > >the rotor faces? In theory it should give a bit more power
 > > >and a little less oil heat.
 > > >
 > > >Paul Lamar


 > >  From Ken Welter
 > > I use ceramic ceramic coating it dropped the oil temp by about 40
 > > degrees. I have it done by performance coatings they can be reached
 > > at www.performacecoatings.com I have run it for about 900 hrs and
 > > would not consider running without it.


Dave Smith wrote:

 Ken ,could you tell us more about this, parts coated, before and after
 performance, aircraft type, ETC.

 Thanks,
 David Smith
 > Glasair I Turbo 13B     mulford@earthlink.net


   Ken Welter wrote

   I put 60 hrs on my coot without ceramic coating and the oil temp
was running up to 260 degrees. When I lost the thrust bearings due to
the Ross gearbox I coated the rotors and it dropped the oil temp to a
peak of 220 degrees. I have now run over 900 hrs and on it and see no
problems with flaking.I have been around ceramic coatings in the
snowmobile world for over 10 years. Every one I know runs it. They
will pay $8000 for a new snowmobile and tear it down to coat the
pistons. Without ceramic coated pistons on a rotax you will have a
melt down after 1250 degree exhaust temp. With the coating you can run
up to 1450 degree temp so for any of you rotax airplanes types I would coat them
also.
--

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org