Subject: idle speed - rotary boat
From: ACRE NL
Date: 8/31/2001, 4:38 PM


Hello Peter:

Sorry I didn't get to your e-mail off-line, but since its posted to the list,
I'll answer it here as well.

The engine should idle well at 1000 rpm, even 900 might be OK. Try adjusting
the mixture screws on the carb -- two small screws in the primary float bowl,
one pointing forwards, one pointing aft. Adjust them about 1/4 turn at a
time, adjust both the same amount. Out is rich, in is lean. You may want to
start by screwing them in gently until they just bottom (too tight ruins the
screws!), then back them out 1.5 turns. Then adjust from there. You will need
to keep lowering the idle speed as you improve the mixture adjustment. This
should be done with the engine hot.

If the engine can't be made to idle, there is another problem -- perhaps dirt
in the idle circuit, perhaps a bad power valve (a bad power valve will make
the engine run too rich at idle, and will generally be hard starting also).

Temperature should run about 160F. Your gauge may not match the engine
sender. If the engine housings don't feel really warm after the engine has
run awhile, perhaps it has a stuck thermostat (or maybe missing -- as I
recall, that engine had a damaged t-stat housing from handling at a show, and
our ex-salesman in Florida replaced the housing. Possibly left out the
t-stat?)

If it is faster at 4000, wait till you get to 6250. It's at least another 70
hp! (You may need to repitch the prop to get to 6250).

Keep us posted!

Jon Lauter
Rotary Power Marine Corporation
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org