<< Finn I think you need to find a local with a lathe to make parts for you.
 Are you a member of the local EAA chapter? Got any community colleges around
 there that teach machine shop? Send me a sketch of what you need. I can't
 promise I will make it but I might have some suggestions.

 Paul Lamar >>

How about a -3 by 1/8 male pipe fitting  cut down to 1/4 28 or a length of
10-24 bolt brazed into the dash 3 where the 1/8 pipe was cut off , then
drilled through. I received my Omega catalog today. Very interesting.
Lynn E. Hanover.

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org