Subject: Oil Cooler plumbing
From: ACRE NL
Date: 9/13/2001, 1:02 PM


 > >Jerry Hey wrote:
 >>
 >>  I have mounted the stock Mazda oil cooler on the fire wall, with the
 >>  inlet/outlets on the passenger side. The Haynes manual does not
 >>  have a diagram showing how the oil is routed within the engine.  So
 >>  where do I connect the oil inlet hose?  Same question for the outlet
 >>  hose.   Also, do you recommend removing the oil cooler bypass valve?
 >>  (The oil metering pump has been removed.)    Thanks,  Jerry
 >
 >You got a little sketch or picture Jerry?
 >
 >If you remove the oil thermostat in the stock cooler you must plug
 >the bypass hole inside the cooler.
 >
 >The oil metering pump has nothing to do with any of this.
 >
 >Paul Lamar

 Thanks Paul,  the picture you sent is exactly what I was planning to
 do.  I have got the coils in place and also the oil cooler.   The
 exhaust pipes await the arrival of the tangential muffler tube. The
 fuel injection is the cut down version from the stock RX-7 that was
 done by the previous owner of my engine.  He did a beautiful job.  I
 don't think I could improve on his effort.  One piece of the puzzle
 that remains is how to get an air filter on the intake.   Once the
 entire installation is complete, I will  overhaul the engine.  I am
 considering sending  the housings to Bruce Tarrentine for street
 porting.  There will be a NACA vent on top of the cowl to supply the
 oil cooler and a two or three inch round inlet for induction.    No
 matter how you look at it, top, bottom or sides, the cowl will be
 very narrow and streamlined  As soon as I can put together some spark
 plug wires and lines  to the oil cooler,  I will send a picture.
 ---Jerry

Don't forget Jerry that NACA scoop/duct won't work well with an oil cooler.
You need a snorkel type scoop. A think streamlined cowls are a bit over rated.
The ideal aerodynamic shape is a blimp. Well perhaps the prop works
slightly better but only slightly.


If the blimp shape were really faster, I would still build the
streamlined version.  I was looking at an F-4 Phantom a couple of
days ago which also failed the blimp test.    --Jerry

You would be wrong :-) Who said anything about frontal area and supersonic speeds?
For subsonic speeds the F-4 is all wrong. Why do you think the Questair 
Venture is so fast? It looks like a miniature blimp :-)

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org