Jerry Hey wrote:
I have mounted the stock Mazda oil cooler on the fire wall, with the
inlet/outlets on the passenger side. The Haynes manual does not
have a diagram showing how the oil is routed within the engine. So
where do I connect the oil inlet hose? Same question for the outlet
hose. Also, do you recommend removing the oil cooler bypass valve?
(The oil metering pump has been removed.) Thanks, Jerry
You got a little sketch or picture Jerry?
If you remove the oil thermostat in the stock cooler you must plug
the bypass hole inside the cooler.
The oil metering pump has nothing to do with any of this.
Paul Lamar
Thanks Paul, the picture you sent is exactly what I was planning to
do. I have got the coils in place and also the oil cooler. The
exhaust pipes await the arrival of the tangential muffler tube. The
fuel injection is the cut down version from the stock RX-7 that was
done by the previous owner of my engine. He did a beautiful job. I
don't think I could improve on his effort. One piece of the puzzle
that remains is how to get an air filter on the intake. Once the
entire installation is complete, I will overhaul the engine. I am
considering sending the housings to Bruce Tarrentine for street
porting. There will be a NACA vent on top of the cowl to supply the
oil cooler and a two or three inch round inlet for induction. No
matter how you look at it, top, bottom or sides, the cowl will be
very narrow and streamlined As soon as I can put together some spark
plug wires and lines to the oil cooler, I will send a picture.
---Jerry
Don't forget Jerry that NACA scoop/duct won't work well with an oil cooler.
You need a snorkel type scoop. A think streamlined cowls are a bit over rated.
The ideal aerodynamic shape is a blimp. Well perhaps the prop works
slightly better but only slightly.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org