Subject: Off Topic - Urethane formed Ribs?
From: ACRE NL
Date: 9/14/2001, 1:33 PM


 > > > > > There is a process where parts are formed over a male
 > > > > die by pressing urethane over the die and the material
 > > > > > to be formed. I would like to learn the process and use
it to make the ribs and other formed parts for a Pazmany Storch. Do
any of the list members know the process ? Can anyone direct me to a
specific source which would provide information on setting the
process?
 > > > > >
Walter Luikey


 This system is common in prototyping and small run stuff.

 The dies are simple and shallow. You can do it with layers of
plywood pulled together with ready rod (all thread) and nuts. Or
run over it with a truck tire.
 Works on thin sheets of dead soft aluminum. Keep the edges rounded
and waxed. For small pieces you can crush it in a press. For ribs
you can make a two piece die with no foam at all in it. Make the
two halves extra long and put a piano hinge along one side to index
it.
 A saber saw and a router with a 1/4" or 1/2" rounding over bit are
required. You will catch on quickly, seeing how much gather you get
or with the metal tearing at the corners. The foam should be firm
and as thick as the die plus a little bit. Make a simple piece like
a tear drop shape at first. Put a scrap of metal on it, lay a
sponge or two from the kitchen on top and then another piece of
plywood, and crush it in the vise. You can start with the
disposable turky trays. They cut easily and form very well. You can
cut darts (a sewing term) in the material to control gather. Start
Friday night and by Saturday noon you will have your first rib.

 > Lynn E. Hanover.

Hi all:

        I was overhauling a DC-9 "surfboard" and we couldn't get a detail
part from MD - so we built form blocks and ran over them w/ a fork lift...
It worked great - I joked w/ QA that we'd have to specify what weight forklift
we used to document the repair for our Repair Station paperwork!

        We formed the part in "O" condition and then sent it out to heat
treat. Sport Aviation has had a great series on metal forming and metal work
in general in the last 6 mos.

Regards,
James


The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org