There is a process where parts are formed over a male
die by pressing urethane over the die and the material
to be formed.
I would like to learn the process and use it to make the
ribs and other formed parts for a Pazmany Storch.
Do any of the list members know the process ? Can anyone
direct me to a specific source which would provide
information on setting the process?
Any assistance would be very much appreciated.
Thanking you in advance, I am,
Sincerely yours,
Walter Luikey
This system is common in prototyping and small run stuff.
The dies are simple and shallow. You can do it with layers of plywood pulled together with ready rod (all thread) and nuts. Or run over it with a truck tire.
Works on thin sheets of dead soft aluminum. Keep the edges rounded and waxed. For small pieces you can crush it in a press. For ribs you can make a two piece die with no foam at all in it. Make the two halves extra long and put a piano hinge along one side to index it.
A saber saw and a router with a 1/4" or 1/2" rounding over bit are required. You will catch on quickly, seeing how much gather you get or with the metal tearing at the corners. The foam should be firm and as thick as the die plus a little bit. Make a simple piece like a tear drop shape at first. Put a scrap of metal on it, lay a sponge or two from the kitchen on top and then another piece of plywood, and crush it in the vise. You can start with the disposable turky trays. They cut easily and form very well. You can cut darts (a sewing term) in the material to control gather. Start Friday night and by Saturday noon you will have your first rib.
Lynn E. Hanover.
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org