Subject: Help needed with Long EZ motor mount
From: ACRE NL
Date: 9/24/2001, 11:56 PM


We had a discussion on this at Rotormotor.

For those that don't want to use the rubber bushing in the
firewall (trick see the jpg) we are trying to come up with a simple
motor mount scheme.

What is the dimension from the upper motor mount hard point
on the Long EZ firewall to the top of the fus?

What is the dimension from the lower motor mount hard point
on the Long EZ firewall to the very bottom of the fus?

See the gif.

I think at this point it will be easier to change the hard points
on the firewall.

Paul Lamar


The upper hard point is ON the upper corner of the fuselage, basically
the fore-aft angle nestles against the upper longeron.  The lower
mounts are bolted to the bottom of the main spar box and to the upper
part of the main gear hardpoints for the gear attach fittings.

I can get the actual dimensions if that is what you want.

Moving the hard points will be extrmely difficult as they tie into inserts
in the center section spar and into the longerons and the main gear mount
hardpoints.  All these are hard to relocate.

Bill Freeman
Long EZ builder & pilot
BSME, MSME
EAA Technical Counselor

Can't we just slather on some more layers of inside carbon fiber and tie
the whole ass end onto the spar?

Paul Lamar


No need for carbon, it isn't a stiffness problem.  What is
wrong with attaching to the original mounting points???
The bed mount attached to the original points should be fine
unless it is too narrow.  You can reinforce the firewall, but
why not use the original hard points, just a different space
frame?

The real problem is a CG problem with all that cast iron back
there.  The LE was designed for the O-235 WITHOUT a
starter.   A rotary with a starter is guarenteed to need some
lead in the nose.  Not a good airplane for an experimental
engine, IMHO.   The RVs have a much lower landing speed,
better for an off field landing.  Min speed on a LIGHT LE
like mine is about 58 kts, at full aft stick.   Many of the
heavier birds have a min speed of 65 or more kts.   I bet
the RVs are 10-15 kts slower.

Bill Freeman
Long EZ builder & pilot
BSME, MSME
EAA Technical Counselor

Carbon is lower density than fiberglass for the same tensile 
or compressive strength.

The stock firewall hard point mounts are in the wrong place for a rotary. 
They are also not spread very wide at only ten inches vertical. This puts 
a tremendous load on the firewall hard points with a six G pull up when the engine
CG is 15 or so inches aft of the firewall. Like 2250 pounds pull
at the top and 2250 push at the bottom not counting 1500 pounds shear.
This is assuming everything else is hung from the firewall which
is probably not the case.

It would be better to spread the mounts vertically as Perry has done
or move them to better locations. How many layers of glass would we need
in there to make the aft fuselage an extension of the spar so to speak?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org