We had a discussion on this at Rotormotor.
For those that don't want to use the rubber bushing in the
firewall (trick see the jpg) we are trying to come up with a simple
motor mount scheme.
What is the dimension from the upper motor mount hard point
on the Long EZ firewall to the top of the fus?
What is the dimension from the lower motor mount hard point
on the Long EZ firewall to the very bottom of the fus?
See the gif.
I think at this point it will be easier to change the hard points
on the firewall.
Paul Lamar
The upper hard point is ON the upper corner of the fuselage, basically
the fore-aft angle nestles against the upper longeron. The lower
mounts are bolted to the bottom of the main spar box and to the upper
part of the main gear hardpoints for the gear attach fittings.
I can get the actual dimensions if that is what you want.
Moving the hard points will be extrmely difficult as they tie into inserts
in the center section spar and into the longerons and the main gear mount
hardpoints. All these are hard to relocate.
Bill Freeman
Long EZ builder & pilot
BSME, MSME
EAA Technical Counselor
Can't we just slather on some more layers of inside carbon fiber and tie
the whole ass end onto the spar?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org