We had a discussion on this at Rotormotor.

For those that don't want to use the rubber bushing in the
firewall (trick see the jpg) we are trying to come up with a simple
motor mount scheme.

What is the dimension from the upper motor mount hard point
on the Long EZ firewall to the top of the fus?

What is the dimension from the lower motor mount hard point
on the Long EZ firewall to the very bottom of the fus?

See the gif.

I think at this point it will be easier to change the hard points
on the firewall.

Those [new] mounting points look low.  Maybe it can work, but
I think you will have to beef-up the firewall in some manner.
Maybe Bill Freeman has some ideas.  I was going to copy
the Cozy IV plans to beef up the firewall for the rubber in
the firewall mount.

This drawings shows the water lines so you can scale from it.

The stock lycoming mount extrutions are bolted to the spar/
fuselage spruce stringer junctions.

--
Perry J. Mick
Duckt N7XR
http://www.ductedfan.com

Thanks Perry. It looks like your new rubber bushing holes are just alongside
the existing stringers. Is that correct? Can you zoom this gif in a bit
so I can read the writting?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org