The oil pressure was
sagging at the end of the longest straight. The oil tank was over full and
the scavenge pump was blowing bubbles in it and foamed it good. Sound
familiar?
When flow was high (9,500 RPMs) the pressure went down to 50 PSI. Then back
up to 85 on the rest of the lap. I also need larger than 1" ID line to the
suction side of the pump.
Lynn E. Hanover
That is interesting Lynn. Since I redesigned the oil pan I must make a
new oil pickup tube. Should I go larger on the diameter?
Paul Lamar
I wouldn't think so. We ran the stock pickup and pan with just a baffle, for years with no problems. We ran 85 pounds by adding washers to the stock regulator. The baffle was to keep oil in the pan (for the most part under braking, because all of it runs up inside the front cover and uncovers the pickup. One change that made sense to me was to remove the bug screen from the pickup and braze a fillet around the junction of the tube and backing plate. Then cut the tube off below the plate and radius the bottom of the junction with a die grinder into a bell shape. The pressure goes up just a bit, and top pressure under long pulls doesn't wander around so much. If the stock pump is being used there is no advantage to making the pickup tube larger. My sump tank is in the right side foot well area with a one inch ID hose to the pressure pump (Peterson) on the left side of the engine. The 4 foot long suction hose provides too much drag for the pump with a slight centrifugal compone!
nt in
left turns. A 1 1/4" formed
tube will be better. Again, none of this should be a problem in an aircraft installation. We run larger bearing clearance on main and rotor bearings. So even at lower pressures we are flowing a bunch more (cooling)
oil than a stock pump could. I would like to be running 95 PSI hot. I will be going to a larger oil pump crank pulley this winter.
Lynn E. Hanover
Thanks Lynn.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org