Subject: Reversed NACA Ducts (or the lack thereof)
From: ACRE NL
Date: 9/24/2001, 7:25 AM

Wrathall Mark wrote:

Rick Girard wrote

P.S. while cruising by the Goodrich facility at Paine Field the other
day I spotted a reverse NACA duct tucked under the horizontal stabilizer
of a B 737. It was canted about ten degrees opposite the fuselage AOA
for cruising flight well on to the tail cone.  Didn't have a camera with
me at the time, but I'll keep looking and send a shot when I can get
one.


Mark Wrathall wrote:
The NACA duct , if we use that as a description for the bell shaped
submerged intake, is the APU intake. It is facing forward just forward of,
and well below, the leading edge of the hori. stab. It has a door which is
actuated closed with the APU off. The door has a wing attached to it. I am
not sure if this is to reduce door actuation loads or to help with the thick
sluggish boundary layer back there. Although an NACA duct may not be ideal
in that position, it has a turbine engine sucking hard through it. Remember
from the NACA paper Paul scanned a page from, these intakes are better
suited for turbine intakes than trying to force air through a heat
exchanger.

The location of this intake is not ideal, being directly behind the rear
galley service door. We have had incidents of these APU's ingesting a full
rubbish bag, with corresponding performence loss :). As the APU is normally
only used on the ground, the later Boeings (767/777)  just have a simple
scoop like door which is driven out into the breeze by a pneumatic actuator.
They are now at 1 o'clock by the fin leading edge.

The rearward facing parallel sided exhaust duct is the APU  bleed dump, to
exhaust excessive bleed air. It is located at 5 o'clock below the elevator
LE. This form of parallel sided exhaust is used a lot on airliners (Aircon
Pack Heat/Ex exhaust, Engine Core comp cooling exhaust etc) . It is shaped
to turn the flow back into the surrounding flow. Someone (Tracy?) has a
sheet metal curve on the bottom of their firewall to perform the same task.
The bell shape would add nothing to this.

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

737_APU_intake2.jpg

737_APU_compartment_exhaust_2.JPG