Subject: still no flywheel?
From: ACRE NL
Date: 9/24/2001, 11:24 AM


Hi Paul.  Thanks for helping me.  I understood the flywheel was heavy (20
lbs).  I have that auto transmission rotor balance you suggested, but no
flywheel.  I also want to move the starter motor to the other end of the
engine where there is much more room, away from the prop slipstream.  There
will be no rear housing.  This will be direct drive with an 8" shaft
extension.

A few more questions if I may:

1.  Who is Duncan so I can contact him about this?

He disappeared which is probably a good thing. Perhaps one of
his frustrated customers did away with him :-) PL


2.  Why is it not an easy thing to do?

much thanks ...........don


Well you need the front of the engine to drive the accessories so
a total redesign will be required at that end. Why don't you use a
ten inch extension and leave the starter in the back like Perry
Mick is doing? Perry used a chunk of the stock bell housing to
mount the starter. His extension shaft is above the starter.


Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

starter-location.jpg