Well, I don't know the RVs very well, but I avg 150 kts GS on a little less
fuel burn with my O-235 (low compression) 108 hp. Usually I burn less,
maybe about 6.2-6.4 at under 8k MSL, and down to 5.6 or so at 12K MSL.
6.2 gph * 6 = 37.2 lb/hr / 0.45 lb/HP-hr = 82.66 HP / 0.75 = 110 hp,
so I'm running VERY close to 75% power and 0.45 BSFC at 150 kts
which is 173 mph. If I was running exactly 0.45 BSFC and 75% the
answer would have been 108 HP. I can live with a 1.8% error in this kind
of "bak of the envelope" calculation.
Now Tracy is burning 6.6 gph, at 160 mph.
6.6 gph * 6 = 39.6 lb/hr /0.45 = 88 HP
or
6.6 gph * 6 = 39.6 lb/hr /0.50 = 79.2 HP
or
6.6 gph * 6 = 39.6 lb/hr / 0.55 = 72 HP
or
6.6 gph * 6 = 39.6 lb/hr / 0.6 = 66 HP
My Long EZ will do 173 mph on about 83 HP. I wouldn't be surprised if
a RV4 would do 160 mph on between 66 and 72 HP. If we do a cube
regression on my Long EZ, we have my bird needing 21% less HP at 160
mph compared to 173 mph, or about 83 * 0.79 = 66 HP.
OOPS ! Accidentally stumbled into a BSFC of 0.6 for Tracy's bird (i.e
66 HP
@ 160 mph). I actually think the RV4 is a bit faster per HP than the LE
(i.e. a bit lower drag), but perhaps not; really not sure. If they're
the same
drag, then I'm right on with my 0.6 BSFC estimate.
Either way, I stand by my view that until you run a pair of similarly
loaded
(wt) RV4s with similar equipment (like wheel pants on both, etc)
side-by-side
for a couple of hours (4 hrs would be better) one with a Lyc and Tracy's
as the other and then land and refuel, you are out there in the noise and
can tell nothing of real scientific value.
Bill Freeman
BTW -- Tracy - did you get the TAP form via FAX???
Long EZ builder & pilot
BSME, MSME
EAA Technical Counselor
Tracy does not have a low drag RV4 by a long shot.
Look at huge the rad air intakes and the induction air inlet on the cowl.
Last I checked he still does not have a radius on his cowl outlet
and his wheel strut farings do not fit very well. Also he is dragging
that long four inch diameter, four foot long muffler under the airplane.
Sorry Tracy :-)
I think you are high on Tracy's BSFC numbers by at least .01 Bill.
Paul Lamar
Opps I meant .1 and not .01.
Bill, I am going to have to say you are out to lunch on this.
No way is the Mazda rotary 25% or even 20% less fuel efficient than a
piston engine.
I might buy 5% or even 10% but not 25% or even 20%.
Anybody who has owned an RX7 can tell you that. The bad mileage is an urban
myth.
I just found an old issue of the British magazine Car Design % Technology
August 1992. On page 25 the magazine published their data on the following
cars.
Urban Steady Steady Weight
-------------....... 90 KPH 120 KPH Kg
1993 RX7 ... 17.7 37.2 29.4 1265
911 Carrera 2 16.5 38.2 29.1 1380
Porsche 968..19.1 39.2 32.1 1420
Honda NSX.... 21.7 36.2 30.4 1360
1989 RX7 16.9 32.1 26.2 1380
These are official British government figures. The 120 KPH figures
are most relevant to aircraft use but still not up at the same HP
levels.
The magazine calculates a BSFC of 250-260 gm/Kw verses 230
gm/Kw for a "state of the art 4 valve reciprocating units."
Note: in no way is that "state of the art 4 valve reciprocating units."
a low compression aircraft piston engine with two valves and magneto
ignition.
Paul Lamar
260 is 13% greater than 230. Low compression is why LyCons
have 0.45 BSFC and not the 0.42 that you can get with reg gas
autos. The valves on aircraft engines are HUGE and their volumetric
efficiency is excellent, the HP is limited by RPM, but they breath
extremely well. This is a big piece of BSFC, with compr ratio being
the other big factor.
If my Lyc gets 0.45 BSFC and you multiply by 1.13 you get 0.509.
So perhaps your value of 0.50 is close, as I have said, we don't
really know. I don't really know, as I have repeatedly stated.
A side-by-side cross country run with very "drag similar" RV4s is
the only way to really solve this discussion.
Ultimately, even if the answer is 0.6, it is not important. If you
cruise at 85 hp, you will burn 6.375 gph @ 0.45. If you cruise
at 85 hp @ BSFC of 0.6, you burn 8.5 gph. Over a typical 4
hour leg you will burn about 8.5 gallons more of fuel, not a
particularly big deal. If the correct value is 0.5, then in 4 hours
you burn 2.8 more gallons than 0.45 BSFC, an insignificant
amount, and only about 5.6 gallons less than at 0.6. Not very
significant unless you are trying to duplicate Voyager's feat.
Does Jon Lauter have any good dyno data on BSFC for his marine
13Bs?
I'm done on this issue. We've spent more time than it warrants
already. :-)
Bill Freeman
Long EZ builder & pilot
BSME, MSME
EAA Technical Counselor
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org