Subject: 13B car / aeroplane
From: ACRE NL
Date: 9/25/2001, 9:19 AM

Don Dunbar wrote:

Hi guy's,
I would like have my 2 cents worth on this subject as I own a 1987 seqenqual turbo RX7 which has 15000 KM or 9000 miles on the clock. The fuel consumption of this vehicle is great if you can drive it in the condition it was designed for.
The figures that I returned on a long hard driven trip that would most equal the power absorbed by a plane with rotary power are. I covered 310 KM or 186 miles with an average of 110 miles per hour. The speedo was reading 260 KM and 6000 rpm and above on two long straight during this trip.
I was surprised on reaching the next town and gas station as the fuel consumption was so small. They are not meant to drive around town and this hard driven trip proved this as the fuel consumption was better than my Mitsubishi Pajaro running at 130 km per hour or say 80 miles per using 14.5 US gallons per hour. My RX7 returned 15.58 gallons per hour at an average of 110 miles per hour.
It is always hard to compare different installations against simular designs as there can be so many variables. In the marine industry which is my fortay the difference in propeller power absorption and the design of the propeller can vary in efficiency from say 53% to 67% and they can all come from the same manufacture.
Over many years we have had disputes with engine manufacture and propulsion suppliers water jet, propeller manufactures over outputs of engines and propulsion devices. We have used strain gauges to prove which is at fault. It has alway been the propulsion devise with the efficiency be lacking badly.
1# In conclusion it is conceivable to have 10% difference in efficiency in a propeller.
2# Without a Dyno curve of the engines performance we are asking the propeller manufacturer to wave a magic wand.
3# From the dyno test we should ask for the graph's with the power curve and fuel consumption matched to a theoretical propeller curve  and post them for the benefit of the group.
I will post the dyno results on my engine testing.
Regards Don

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org