Rick Girard wrote:
Since I too am putting a 13B in a LongEZ, I am going to weigh in on
Bill's side. The mods you are planning Paul aren't worth the effort.
The firewall bulkhead is only 1/4" Birch plywood right up against the
aft face of the rear spar. Since the spar caps and shear web are on
this surface you are limited to putting any mounts above and below the
spar. By the time you have put in all the reinforcements required to
bring the loads through that thin piece of plywood and tie them into
the
fuselage longerons the question remains, why? As Bill pointed out the
LEZ mounts have a history of success. If you want to improve upon it
utilize what is there and bring the lower longerons into the mix.
Much
easier, no disassembly required, and you aren't betting the farm on a
theoretical improvement with no history behind it.
Rick Girard
Good luck Rick. Send us a sketch of your motor mount so I can
critique it :-) Have you calculated the loads on it yet?
Paul Lamar
My existing mount uses the stock points, with compression struts
down to the bottom stringers. But it has no shock mounts.
I latched onto Paul's idea of rubber mounts in the firewall as the
best way to accomplish that in the Long-EZ. What's the big
deal? Just emulate the Cozy IV for the firewall beef-up, the Cozy
IV has rigid mounts in the firewall at about the same locations I
put the rubber mounts.
I intend to proceed eventually with the rubber mounts in the
firewall, just haven't because I want to keep flying, and need
to develop new intake and exhaust manifolds first.
--
Perry J. Mick
Duckt N7XR
http://www.ductedfan.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org