Bill Freeman wrote:
BIG SNIP
but unless there is some impossible issue of space,
SNIP
Bill Freeman
Long EZ builder & pilot
BSME, MSME
EAA Technical Counselor
Because it is easier to beef up the firewall and aft fuselage than design a
space frame to go around all the ports and water pump inlets and outlets
it has to go around on the right side of the rotary engine.
It is an impossible issue of space.
Three or four layers of carbon fiber or even glass are not going to
weigh that much. What we will wind up with is a simple and cleaner
design that is easier to service.
Just humor me for now Bill and suggest some fuselage beef ups.
Paul Lamar
OK, if space is the issue, we'll fix it. I'd still use the original mnt pts,
how about this idea for your basic bed mount drawing. The
firewall is only slightly attached to the rest of the airframe. Using it
would be a major big deal. But, there are ways to go. The bottom
pickup can't use the NACA inlet side pieces at the lower firewall,
because the NACA is built up on top of the original fuselage bottom
and makes the sides of the firewall about 4" deeper. These are not
strong pieces, originally intended to carry only airflow loads. BUT,
the lower longerons are wood pieces and are directly attached to the
bottom of the gear attach fittings, which are in a VERY strong area
(lower original mt pts are attached to the top of the gear attach structure).
IIRC, these come out flush with the firewall and would be available
to attach another alum extrusion, tying into original major structure.
Will require cutting off the outer skin locally and digging out the fuselage
foam down to the wood, bolting & bonding on a 1x1x 1/8" 2024T6
extrusion with flox to the lower longeron and/or gear attach layup
(about 25 plies). Should be pretty easy. May be room, maybe a difficult
fit, not sure. I'll have to look.
I'll dig out my plans and work up an accurate sketch, but here is one from
memory, which should be close, but may need revision later. Hope you
can read my scrawls.
Bill Freeman
Long EZ builder & pilot
BSME, MSME
EAA Technical Counselor
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org