Subject: Help needed with Long EZ motor mount
From: ACRE NL
Date: 9/25/2001, 12:49 PM


Perry Mick had trouble with his original Long EZ motor mount
design until he added the lower diagonal brace on each
side shown in this picture. Note that it does not go to an
existing motor mount hard point on the firewall. Did you beef
up the firewall behind this point Perry?


Wrong Paul, I've never had trouble with my motor mount.
I drew a 1/5 scale drawing by hand and those struts were
in the design before I even built the thing.  It was obvious they
had to be there.  So I use the four stock extrusions plus the two
struts.  The struts bolt into 1/4 inch aluminum plates that are
floxed and glassed to the firewall right over the lower spruce
stringers.  Did not beef up the firewall, but will for the rubber
mount.

Perry J. Mick
Duckt N7XR
http://www.ductedfan.com

It was obvious to you and it is obvious to me but we are dealing here with
........ :-)

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org