Subject: Oil pickup tube.
From: ACRE NL
Date: 9/25/2001, 7:22 PM


Snip

That is interesting Lynn. Since I redesigned the oil pan I must make a
new oil pickup tube. Should I go larger on the diameter?

Paul Lamar

I wouldn't think so. We ran the stock pickup and pan with just a baffle, for
years with no problems. We ran 85 pounds by adding washers to the stock
regulator. The baffle was to keep oil in the pan (for the most part under
braking, because all of it runs up inside the front cover and uncovers the
pickup. One change that made sense to me was to remove the bug screen from the
 pickup and braze a fillet around the junction of the tube and backing plate.
Then cut the tube off below the plate and radius the bottom of the junction with
a die grinder into a bell shape. The pressure goes up just a bit, and top
pressure under long pulls doesn't wander around so much. If the stock pump is
being used there is no advantage to making the pickup tube larger.
Snip
Lynn E. Hanover
Snip


  Lynn,
       I am a little dense, can you explain a little further (perhaps with a sketch)
how you modified your stock oil pickup.

     Thanks,
     Kelly Troyer

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org