Subject: Help needed with Long EZ motor mount final
From: ACRE NL
Date: 9/26/2001, 5:36 PM


Paul, I would appreciate seeing a Top view of this
arrangement, if time permits of course.

                                 Thanks,
                                  Butch


That is on my list of things to do but next is the lower motor mount
fuselage bracket. I will say however it is a simple parallelogram.
As Perry mentioned, the two inch diameter rubber bushings are right
next to the 12 inch wide engine and the Long EZ motor mount hard points
are about 15 inches apart on the firewall.

Paul Lamar

Paul,

If you could give me the dimensions on those rubber mounts I will model up
something in 3D as soon as I get my head above water. You and I are
basically on the same track. The only difference being that I was going to
tie all three of the hardpoints together with the tubing and make is
somewhat universal so that it could fit an RV 4 firewall, by drilling
different holes. I am going to put both the beam and the tension member
mounts in the tubing that is attached to the firewall.

Monty



Monty,
My scanner is not working again.  I will fool with it this weekend to check for loose connections, etc.  I will send you the motor mount prints for the RV-4 when I get it going.

Ken P.

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org