Subject: Help needed with Long EZ motor mount final
From: ACRE NL
Date: 9/26/2001, 7:07 PM


Here is the simple device I had in mind. A one inch hole is cut in the
firewall aft of the landing gear bolt with a hole saw and extension 
and this is bonded into the hole with micro and glass. The tube inside 
diameter should clear a socket and extension (check it first) for tightening 
the landing gear bolt nut. Shown colored green in the jpg below.

This device will transfers the compressive load from the 
lower motor mount strut directly into both of the landing gear aluminum brackets 
tying the structure into a rigid whole. A side benefit is you can get 
to the landing gear nut with ease  if you take the motor mount off. 

The four small bolts can sandwich the firewall for even more strength.

This can be made from 0.065 wall 6061 or 0.049 4130 tubing.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

spacer.gif

inside-LE3.jpg