Subject: Help needed with Long EZ motor mount final
From: ACRE NL
Date: 9/26/2001, 12:32 PM


OK here is what I recommend. The 4130 rectangular
steel tubing is
now use to distribute the tension load into the two
original hard points. The new lower hard point
adjacent to the
lower longeron that Bill is modifying will take the
lower
compression strut load. Just like Perry's original set
up.

This should work fine and give plenty of room around
the right side of the engine for exhaust, intake and
water plumbing.

The triangles should be braced on both sides either to
the first
wing rib or forward diagonally to the spar. Your
choice. There is very
little side load so this is mainly a stiffness issue
so 1/4 ball
jointed 1/2 inch diameter struts could be used.

Underneath the pan and between the rubber mounts there
will be plenty
of room for a 12 inch wide radiator. No diagonal
tubes. The pan is
not shown but a custom aluminum pan is recommended but
not required.

The front mount is not shown but any one of a number
of schemes will
work as there is little or no load. The rubber bushing
shown are on
or near the CG of the
engine/psru/starter/alternator/prop combination.
I recommend welding something on to the front panel of
the pan for
a front mount.

Paul Lamar

Paul, I would appreciate seeing a Top view of this
arrangement, if time permits of course.

                                 Thanks,
                                  Butch

That is on my list of things to do but next is the lower motor mount
fuselage bracket. I will say however it is a simple parallelogram.
As Perry mentioned, the two inch diameter rubber bushings are right 
next to the 12 inch wide engine and the Long EZ motor mount hard points
are about 15 inches apart on the firewall.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org