Here is my final sketch on the Long EZ motor mount.
I added a bottom view Butch.
After this the RV4 ought to be a piece of cake :-)
Paul Lamar
Except that the RV4 main landing gear is integrated into the mount and
the RV4 firewall isnt flat. The RV4 firewall has a large wedge shaped
protrusion into the engine compartment to clear the rudder pedals.
I think somebody in this thread was implying a common design which could
be used for the EZ as well as the RV4. The RV4 config is different enough
that I dont see this approach as being valid. Not saying its harder, just
different.
Mike Wills
I totally agree Mike and I think I said so in an earlier message.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org