Paul and All,
Has anyone on the group come up with any numbers
on the Cad. vacuum pump capacity(How many instruments
it will pull)?
Kelly Troyer
--
Dyke Delta/13B Rotary Power
Don't think so. Not so far.
Paul Lamar
I don't know it's capacity in # of instruments, but it pulls about a
20-24 psi vacuum so it should be plenty. Others on the rah ng say
they've been using it for years.
AI Nut
20-24 psi vacuum????? No way!!!! 15 psi is absolutely no air at all.
That is as low as you can get. Nothing there! No air molecules!!
Nada!!!
Paul
I believe that the gentleman MEANT to say 20-24 inches of mercury.
(This of
course is on a closed system) These pumps were also found on early 80s
Oldsmobile diesels. The Oldsmobiles came with either 4.3L V-6 or 5.7L
V-8
diesel engines. I had a 1983 Olds Cutlass Ciera with the 4.3L V-6. I
know
that there were many problems with the 5.7L V-8 engine. My V-6 ran very
well
and for a long time. I've never measured the capacity of these pumps. I
suspect that it would be more than sufficient though. In my limited
experience, this pump was durable.
Charlie Kuss
This may mean 20 to 24 inches in a water monometer or a tube filled with
water. Put a clear tube 6ft in the air and conect one end to to vac pump and
the other in the bucket of water. this will give the amount of vacuum.this
can be calibrated to mercury and as it is much heavier the lift is much
less. The amount of vacuum can be measure by the time it takes to pull a
volume to a predescribed vacuum.
Regards Don
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org