Subject: stock all alum radiators
From: ACRE NL
Date: 10/9/2001, 3:05 PM
CC: Bruce Frank



Subject: (rx7) [2] [3] Radiator Prices are in


Fluidynes


FC 86-92 Rx7 - $439.00 + shipping
FD 93-96 Rx7 - $439.00 + shipping


Koyo


FD 93-96 Rx7 - $399 + shipping

Just for comparision to those custom made radiators we are installing.
These are near stock size (maybe a bit thicker, like 3/8"), all aluminum
units with stock inlets and outlet fittings.
Paul, how would you rate the heat transfer rate of the stock radiator in an
aircraft application (your slow airspeed full or near full power climb) for
size? Methinks they are adequate for cruise, they are big and thin.

Marc Wiese

These are rip off prices as Fludyne is selling a bunch of the almost stock RX7
aluminum configurations. One can buy similar sized radiators from Summit Racing 
for half this price. The stock unit might work for a normally aspirated six port
13B two rotor.  

As I have discovered it is not real difficult to remove the plastic tanks 
and tig weld on new all aluminum header tanks. Just bend up the tabs straight 
and fit the new tanks down inside letting the tabs overlap. In most case 
you don't even need welding rod. Just melt the tabs and merge it with the 
melted header tank material. Pretty easy to do if you make the header 
tanks out of .065 thick 6061-0 material.

The header tank end joints should look like this:
 ______________
|____________
| |
| |

and not like this:
   ____________ 
 _|__________
| |
| |

The later is much much harder to TIG weld.


The joint between rad and header tank should look like
this:


......... NEW HEADER TANK
......  _______________
...... |_______________
...... | |
...... | | 
...... | |
...... | |
...... | |
...... | | 
WELD  /| |
.... | | | 
.... | | |
.... | |_|_______
.... |___________  RAD
......... CORE

This is real easy to TIG weld.

The dots are to keep the email program from deleting spaces
in the ASCII art.

If you make the tanks and fit them a commercial welder probably
will not charge much to TIG weld them.
Check with Bruce Frank at <bafrank@worldnet.att.net>

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org