Paul (and other Tech Guys),
Attached is a picture of the the 1st prototype for the left upper mount.  I will be rebuilding it to make it lighter (presently 1 lb 12 oz) and to extend further to the rear. Note that the loads should be almost entirely horizontal - the mount attaches to the PSRU end of the engine in 2 places (with gussets) and this should be the main points that pick up the loads.  The rear of the mount attaches to the water pump with 3 bolts and to the rear end housing with a 6MM bolt.  This is a peripheral port engine so there are a few more places to attach brackets on the left side of the engine.  Any suggestions would be appreciated.
Ken Powell
kenpowell@aristotle.net

Looks like it will work. So far so good.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org