Subject: Determining top dead center with oil
From: ACRE NL
Date: 10/15/2001, 10:31 PM



<<    If a number one rotor apex seal is visible in the center of the lead
spark plug hole, where is the engine in relation to top dead center?  If that
information is available, then I could make my own timing protractor.  And it
shouldn't make any difference if it's for a 13b or a 20b.
 >
 > Any help would be appreciated.
 >
 > Bob Darrah


 You got me there. It is past top dead center for sure.

 When the 13B is at top dead center on the #1 rotor
 the V belt pulley key slot is at the 9 O'clock position. I have no idea
 on the three rotor. Tracy might be able to tell by looking at his.

 I don't think there is any reliable way of measuring top center
 through the spark plug holes as can be done with a piston engine.
 Lynn Hanover may know a trick.
  >>


I pack up the seals with bearing grease when I build a new engine. I have a
spark plug modified with a piece of 1/8" brake line through the center. I
turn the engine the (excuse the expression) "plugs up" position. With number
one rotor short of where I think TDC should be, I fill the chamber with ATF.
I install the special plug with a length clear plastic tubing taped to a pain
stirring stick to hold it upright. I use a breaker bar to rock the engine
back and forth past TDC. The ATF in the tube moves dramatically with this
motion. I watch for the ATF to reach the highest point in the tube. I rock
the engine back and forth across this highest point using less motion each
time. I note the two points on the degree wheel where I can detect motion in
the ATF column. Half way between the two points is TDC. If the little wire
pointer is right on you have finished. I sight down along a stud or the side
of a nut past the pointer to the TDC mark on the pulley. We use smaller
diameter pulleys and the edge of the pulley is some distance from the stock
pointer. If there is no TDC mark on the pulley use a triangular file make a
groove in the engine side flange and fill it with white paint.
Measure the OD of the pulley at the engine side flange. Use C=3.1416x
diameter.
Divide C by 360 (degrees). Mark the pulley at 20-25-30-35 degrees. File
grooves and fill with paint. Maybe red paint where you want to run at top
RPMs. You only need to do this once, and then only if the pulley is not
marked where you need it to be.

Lynn E Hanover

Very very ingenious Lynn. Thanks a bunch. Neat trick. I might add the best place
to put the timing mark is on the ring gear end which most of us with engines
in airplanes always have easy access to. Here is a picture of what I am talking
about. Using this pointer timing is far more accurate than on the front pulley.
The pointer can be anywhere on the back housing that is convenient to get to.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

flywheel-timing-mark.jpg