Jerry Hey wrote:
Hi Paul, My wife and I attended the Cart Race
at Laguna Seka
yesterday. We
were sitting at the hair pin and saw the
incredible end over end 360
crash
by Oriol Serbia. He was unhurt it turned out,
probably because the car
landed on its wheels. Still, it was a violent
crash that had us worried.
Anyway, rounding a corner in the pits I suddenly
came across a neat
little
race care with a 13-B engine. It is the first
time I had seen one. It
turns out that Formula Mazda was running in the
last race of the day.
They
had more than forty competitors.
These are normally aspirated engines, chip
limited to 6800RPM. They
turn
out about 180 hp. The engines are sealed and
according to the
owner/driver
I was talking with, they usually run the entire
season without a tear
down.
I don't think we can treat our aircraft engines
as hard as these guys
do.
I was very pleased to see that they were running
exactly the same dual
belt
water pump/alternater set up that I have on my
engine. I did not have a
camera so we bought a $10.00 throw away. I
think their cooling set up
is
ideal for aircraft installations. Enclosed are
three pictures, such as
they
are. These cars are being built in California,
so we can get better
pictures. Who knows maybe they will sell us a
few parts. The water
pump
upper neck (not the stock item) is connected
via a short hose to a
stand
pipe that could be mounted to the fire wall. The
radiator cap (16 lb.)
is on
top of the pipe. Both radiators are mounted low
and have bleeds running
to
the upper stand pipe. The over flow line is
also visible in one of the
photos if you look carefully. The hose from
the water pump attaches
high
on this pipe. The outflow to the radiator is
from the bottom. Very
clean
and very simple. It fits my project to a "T".
For those guys who have
not
modified the water pump neck, the stock neck
actually points in the
right
direction in this scheme. Never thought I'd be
able to say that!
I will try to find out more about these
engines. Jerry
Isn't this the same as Lynn Hanover's 25 year old
Cooling system design? ..............If not where does
it differ?
Butch
I don't agree with the restricter in this diagram. I think it better
to up the overall system pressure rather than use a restricter to
increase the pressure in the just the block. I also think it unnecessary
to have two pressure tanks in series. I think the Stant pressure
cap would work fine on the propane bottle alone. Simpler and lighter.
We usually don't have room for the implied extra height of this system.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org