Subject: The piston verses the rotor.
From: ACRE NL
Date: 10/17/2001, 8:50 AM

Don Sherman wrote:

The rotary doesn't fit the Miata much better than the V6.  It needs a huge
tunnel. ds

It is lighter than the Ford V6  by 200 pounds.

New floor pan. Better torsional stiffness if done right. 

The rotary block is 14 inches high. If the drive shaft is 3 inches dia. 
that makes the top of the tunnel 8.5 inches give or take an inch up from 
the bottom of the car. Given six inches of ground clearance under the engine 
that would make the tunnel only 14.5 inches up from the ground at the end 
of the transmission. Give it another inch or two for the new low height 
oil pan on the RX8 motor.

Take your yard stick, place your thumb at 15 or 16 inches inches and hold 
it vertical next to your chair.

Somehow I don't buy the tunnel argument.
 
The current RX7 is a low car and the tunnel is not overly obtrusive.
 
Paul Lamar

AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org