> > They will sell some of the parts that they make like that intake
manifold.
 > >
 > > Paul Lamar

Paul,
Could that manifold be used as a starting point for installation in KIS, or
is it too high for cowl clearance?

Bill Schertz
KIS Cruiser #4045

It would be possible I guess. You might need a slight "power bulge" on the 
top of the cowl.

Probably much easier to do then making a super low height intake manifold.
The big problem is it is not really tuned for any RPM range.
The individual port runners are way too short for 6000 to 6500 RPM.
Probably work good at 9500 RPM but then Star Mazda uses a rev limited
set to 6800 or so.

Star Mazda does not really care about max HP as all the cars have the same
HP specs and rev limiters. This is strictly intended as a drivers
series. The engine was chosen for its long term durability under 
racing conditions.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org