Subject: Blake's shop/RV-4 redrive plate
From: ACRE NL
Date: 10/21/2001, 8:33 AM



         I'm interested in one.  Mine is for an RV-4 and though I'm not
planning to use the wide mounts on this picture I need something like this
to mount Tracy's redrive (when he gets the 2.85 version ready)..  Of course
this would be a batch operation but one with only the starter mount
sticking out would be nice.
         $300?   Well...that would have to look real pretty for $300 (yes,
I'm a cheapbastard).
         My memory fails me, does the thickness need to stay the same for
Tracy's redrive or can it be thinner if I'm not using it for the motor
mount?

Mike

Mike McGee, RV-4 N996RV, O320-E2G, Aurora, OR
13B in gestation mode


Yes it needs to be 1/2 inch thick. The web could be as little as 1/8 inch
thick
in the bottom of the pockets. What width would you like for the motor mount
brackets?

Paul Lamar

         I'm not looking at using it for the motor mount at all.  That's
why I only want enough sticking out to mount the starter.  I'm going to do
the sandwich with the oil pan that includes the windage tray (keeps the
aerobatic oil displacement under control).  This will extend out the side
and rest on a bed mount I'm working on.
         I don't have any good drawings to send yet or I would.  I quickly
plagiarized one of your RV-4 mount drawings to give you an idea of what I'm
talking about.  The RV-4 has a sort of tunnel that runs forward from the
spar (F-413R & L for the RV-4 guys).  I am going to extend that and have it
widen out enough to let the engine rest on it.  It will require some rework
of the fire wall and a work around for the gear but I think when it ties
into the forward fuse it will be a little cleaner and stiffer than trying
to work with the original mount system.  It sounds complicated but as much
as I've thought about it, looked at the plans and sketched it out it really
isn't.  I'm going to try and get this CADed up this week and I'll post it
up for critique.
         Ya know, the more I look at this the more I think I should just
cut up a bell housing for the redrive mount.

Mike

Mike McGee, RV-4 N996RV, O320-E2G, Aurora, OR
13B in gestation mode


Not a bad idea. The Bonanza, Cessna P210 and the Questair Venture use an
aluminum  structural lower cowl. You will need to feed those landing
gear tube socket loads into something substantial. Where are the rubber mounts?

 The bell housing is too deep. It needs to be 3.040 inches
deep as I recall.

Paul Lamar


Hi Mike,
That is a really interesting idea.  There are 4 of us on the list building RV-4's and we are all developing a different mount system.  Mike Wills is in the lead though, as he is the only one close to flying.  I am taking Paul and Mike W.'s advise while trying to develope a cantilever system in order to keep the motor mount out of the way of the radiators and exhaust.  Mike's last bit of advise to me was to spend the extra $200 for a custon CR Radiator and not be limited by the stock radiator sizes.
Ken Powell
kenpowell@aristotle.net

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org