Subject: New RV-4 motor mount system
From: ACRE NL
Date: 10/22/2001, 9:38 AM


SNIP ..........e

         Ideas & critiques are always welcome.  I wish I was making it to
Tracy's next weekend to catch up with the rest of you guys.  I would be
lobbying for that 2.85 redrive!  My EC-2 should be shipping soon so
hopefully I'll have this thing running on the test stand next month.

Mike

Mike McGee, RV-4 N996RV, O320-E2G, Aurora, OR

OK I just found the full size set so here are better jpg's.
I am likeing this idea more and more.

Paul Lamar


Paul, I like this too.  I have to give this some more thought.  I am anxiously awaiting drawings.  I will keep working on my cantilever mount for the moment though.
Ken Powell
kenpowell@aristotle.net

The only thing I have found that is a little shaky so far are the loads and stresses
in the aluminum angles at the top of the tunnel are real high. More later on this.
BTW the same thing can be done with tubes and probably a lot easier to do.

Paul Lamar

I checked it out and the worst case scenario is a hard landing when the loads
from the engine mount and the landing gear loads add together to result in
a stress of 70,000 psi in the 3/4 by 3/4 inch .125 thick aluminum angles at 
the top of the tunnel running through the cockpit back to the spar. That 
assumes there are no rivet holes in the angles and the skin riveted to 
them adds nothing. If you go this route you need to beef up those angles 
and all the clips that feed the landing gear and motor mount loads into them. 
I would use 4130 steel sheet for the clips. The devil will be in the
details.

It is not for nothing that Van put a motor mount hardpoint on the top of 
the firewall for motor mount loads.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

rv4mloa6.gif

rv4mload.gif