<< Robert Darrah wrote:
>
> Help!
>
> As I understand it, on a turbo car, manifold pressure (vacuum) is piped to
> the fuel regulator to increase fuel pressure the further the throttle is
> opened (higher manifold pressure).
>
> In an airplane, we could hook it up the same way, or, leave it open to
> static. If connected to static, the higher you fly, the lower the fuel
(and
> static) pressure.
>
> Using Tracy's ECU, which way is correct? Also, Tracy, if your up coming
> fuel flow indicator is based on injector duty time, how is this variable
> fuel pressure compensated for? Or, how do I avoid the variable fuel
> pressure? It looks to me like the ECU could be programmed to do either
> better using a constant fuel pressure.
>
> Confused minds want to know.
>
> Bob Darrah
> turbo 20B
The flow rate through the injector is dependent upon the delta P of the fuel
across the injector orifice. By having fuel rail pressure a constant
increment above manifold pressure, the flow rate of the injector can be
accurately controlled by the pulse time regardless of manifold conditions.
The fuel pressure regulator with manifold pressure connection achieves this
desireable condition -- fuel pressure at a constant increment above manifold
pressure. Now the ECU can calculate the injection time based upon air mass
flow (calculated in a variety of ways) without needing to understand how
delta P across the injector affects flow rate.
I think that allowing the fuel pressure regulator to sense ambient pressure
would make the job of calibrating the fuel system much tougher. You'd be
adding the injector orifice characteristics into the mix, and not gaining
anything by doing so.
I don't know the particulars of Tracy's EFI, but I imagine it is either a
speed-density system, where the manifold pressure is a key input (obviating
the need for an ambient pressure sensor), or it is a speed - angle system,
where throttle angle and engine speed are the primary inputs for mass flow
calculations, and then an ambient pressure sensor would be important to
adjust for barometric and altitude pressure changes.
Jon Lauter
Rotary Power Marine Corporation
Tracy uses manifold pressure and RPM as well as manifold air temp I think.
No throttle position sensor. Whether it uses it or not it would be a good idea
to use manifold air temp as an input. This would anticipate the conditions that cause
detonation in a turbo engine and automatically richen the mixture and/or retard
the ignition to prevent detonation.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org