Subject: Marcotte group buy
From: ACRE NL
Date: 10/24/2001, 2:24 PM


 > > > Peter Cowan/Lexi Cameron wrote:
 > > This is very likely going to be difficult to put together.
There are three now that have an interest: George Whelan, Marc and
me. Please send me a note if you want to persue it further:
peterc@pipcom.com

Rodger Hilyard wrote:

  A friend of mine is building a 4/9 scale B17....with
 4@13B's, the offset
 of the drive is an asset as he needs to raise the inboard
 engines some to bring
 the landing gear tire higher in the nacelle.

  If the marcotte is a proven design, he is ready to
 buy.......Rodger

The Marcotte lowers the engine relative to the thrust line and not
raises it????
He will get less clearance for the tires and not more. Unless of course
he wants to run the engine upside down but I don't recommend that.

Four Mazda rotary engined B17????  Wow! Wonderful! I can hardly wait.

Paul Lamar



>From Ken Welter
  If you need an offset for your B17 I can build my cog belt redrive
the offset to raise or lower the engine here is my price list that
has the ratios and offsets.

     COG BELT PSRU units for mazda

      ratio       center to center distance

       2.25          6.61  and  8.28
       2.37          6.73
       2.8           9.38
       2.95          11.25
       3.11          11.50

       price $ 3000

      Soon to be available PSRU units for subaru


     COOT Parts List

       Spar pins set of 4                  $ 125
       Hull                                $ 1500
       Front deck                          $ 100
       Tail fairing and rear deck          $ 500
       Tail cone                           $ 75
       Rudder tip                          $ 50
       Elevator tips                       $ 100 pr
       Engine cowl ( mazda or aircraft )   $ 175
       Canopy and door kit                 $ 450
       Droop tips                          $ 500 finished $350 unfinished
       Sponson stub-wings                  $ 450
       Wing leading edge for 30-613.5 Airfoil
       with the ribs installed             $ 1000
       Stabilizer leading edge with 5 ribs $ 250

                    Ken Welter
                    32109 NE 86 ST
                    Camas WA 98607

                     360-834-4089
                     360-253-0703 Cell phone

                     Email  rotary.coot@verizon.net




The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Ken-Welter-belt-drive.jpg

Ken-Welter-Drive-Sprockets.jpg