. I have it plumbed to the radiator with a
cutoff valve. I would strongly suggest one as should a leak
develop
this
would enable you to shut off the hot water.
Ed, you need TWO shut off valves if you expect to close off a break
in
the
heater core. One will stop the hot water from going through the
core,
but
there is enough pressure in the system to force fluid out from the
socalled
suction side.
Bob Darrah
Excellent point, Bob.
Unless you have a one way flow valve in the return line you would
still
end up with hot water in the cockpit. Well, I guess its a good thing I
even
used stainless steel braided hose for that system, so hopefully no
leaks.
Ed
Got in on this one a little late. Yes, definitely use a check valve on the
outlet side of the cabin heater core (perhaps even located forward of the
firewall). This will prevent (or at least minimize) back-leakage if you
spring a leak in the cabin hose, while the shutoff valve will prevent flow
on the incoming side. Again, I should think placing it forward of the
firewall would be a good idea.
Tom Kendall
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org