Peter Cowan/Lexi Cameron wrote:
We have four (of the minimum five) people interested in ordering the 300 drive (2.4 ratio). After another conversation with Marcotte in which I passed on to him the concern about the unit being short: 10.5 inches, he stated that he also has longer units.
For the rotary engine he has a case that gives 18.5 inches from engine to prop flange (This was designed for someone's pusher installation but also works in tracter). These longer cases do add about 8 lbs to the 47 lb weight (so I suspect it is this case that has folks thinking that the marcotte is 10+ lbs heavier).
Snips...
This is not the reason that I think the unit is ten pounds heavier.
I was referring to the short case. The unit is ten to fifteen pounds heavier because
of the massive size of these parts and the massive size of the case required
to enclose them. Ironically and despite the massive size of the parts the critical
gear line contact length is one third of the length of a Ford planetary. Sure the parts are
pretty and nicely made but it is not good aircraft engineering to design a device
that is ten or fifteen pounds heavier than it need be. It is just plain dumb
to add a 60 pound PSRU to a 190 pound engine. Even if it is made in Canada :-)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org