Subject: using aluminum brazing/solding to tack weld before TIG welding?
From: ACRE NL
Date: 11/3/2001, 8:28 PM


Perry Casson wrote:
For you TIG welding gurus:
I've got most of the parts for my Mike Wills style intake manifold
http://eaa245.dhs.org/perry/mike_wills/Mike-Wills-intak007a1.jpg fabricated
but as I'm not set up to weld aluminum I'm going to have to send it out to a
welding shop.   Building a jig to get all the little parts in the right
place would be no small task.   I was wondering if I tack welded the parts
together using aluminum brazing/soldering rod would the TIG welder be able
to weld over it OK?  All the tubes/parts are 6061t6 if that makes a
differance.
Thanks,
Perry Casson


A low temp brazing rod (e.g.. Aladdin) can have a weld over it. The weld will not
be of high strength and it is a pain in the ass to do since some areas will melt
at different temps. And temperature control is the whole point in welding.

I'd ask whomever was doing my welding if it was ok on his end. But if I didn't
have a TIG it is a definite option.
Blake

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org