Perry Casson wrote:
For you TIG welding gurus:
I've got most of the parts for my Mike Wills style intake manifold
http://eaa245.dhs.org/perry/mike_wills/Mike-Wills-intak007a1.jpg fabricated
but as I'm not set up to weld aluminum I'm going to have to send it out
to a
welding shop. Building a jig to get all the little parts in the right
place would be no small task. I was wondering if I tack welded the parts
together using aluminum brazing/soldering rod would the TIG welder be able
to weld over it OK? All the tubes/parts are 6061t6 if that makes a
differance.
Thanks,
Perry Casson
Contact "Bruce A. Frank" <BAFRANK@worldnet.att.net>
Paul Lamar
"Bruce A. Frank" wrote:
The low temp soldering/brazing filler rod is not compatible with the TIG
welding process. That "solder" is not really aluminum and boils out when
one tries to weld over it. If you can tack weld with that stuff then why
not weld up the whole manifold with that process? In my experience it is
strong enough. There are also flux coated oxy/acet aluminum welding rods
that will do a perfectly adequate, though not pretty, job.
Bruce A. Frank
Perry if you don't want to do this. I will tig tack weld it for you and
then you can give it to Bruce to be welded or I can give it to my local tig welder.
You will then need to pay my welder. I am not good enough yet to do a good
overall job. Bruce does a better job than my local tig welder.
Are you willing to weld it Bruce, after it is tig tacked together? We have
quite a few of these intake manifolds to make.
Plan B. Get Mike Wills welder to do another one.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org