Subject: Housing O-Ring shoulder repair
From: ACRE NL
Date: 11/4/2001, 1:54 AM


Chuck wrote:

I am rebuilding the engine I first flew my RV-6 on. It saw 80 hours in the
air after being rescued from a wrecking yard. I removed it because of
excessive oil consumption due to overheated rotor oil scraper O-rings. I
found a 0.40" portion of the wall that retains the inner water jacket O ring
on the center housing was broken. The wall is only 0.045" thick here. I
never noticed any ill effects while the engine was in service.
Here is a Jpeg of what I did to fix it.
I have not yet decided whether to use this housing.

Chuck Dunlap

That looks like a good way to repair those types of failures.
Great idea Chuck. Thanks for sharing that.


Chuck:
I had something of the same idea, only to mill out the whole O-ring wall the lenght of the port. Take out
the whole weak spot. Your way leaves some of the thin wall there to still brake later on. Then I was
going to epoxy the plate in place. Just make a small lip around the whole port. I was thinking of using
a thin piece of SS plate.
Rich Gillen

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org