Subject: Six pinion 2.85 drive.
From: ACRE NL
Date: 11/4/2001, 1:42 AM


Ian & Irene Beadle wrote:

Paul, it looks like making a 2.85 drive using the six pinion
will be
difficult as there does not appear to be room for the drive bolts.
It
certainly won't be a drop in replacement in the Ross box. Mine has
done
40
hours trouble free so far.
Ian RV6A
beadles@webace.com.au


That could be. It will be easier for Tracy however as the end of
his
prop shaft is splined and that should fit the six pinion planet
carrier
but maybe not. I just took a look at it and the spline on Tracy's
shaft is slightly larger. It looks like the the new six pinion
steel
planet
carrier can be bored out and re-splined to fit Tracy's prop shaft.

What about drilling the pinion shafts and using six 1/4 inch
bolts to bolt it to the Ross prop shaft flange.


Paul Lamar


IMHO, drilling the pinion housing for drive bolts is the wrong way
to
go.
It makes the drive un-maintainable for the owner, increases the
labor
content and does not allow for the self-adjusting clearance needed
for
optimum load sharing of the pinions.  I will use the stock spline
and
have a
new prop shaft made to fit.  This way you can go to Ford for
replacement
parts.   The new shaft is a $7000.00 financial hit but worth it in
the
long
run.  Making these investments is what Ross was trying to avoid but
you
see
where it lead.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com


This reminds me of how I had to work on Richard VanGrunsven a few
years
before  he relented and designed the four place RV10 :-)

Paul Lamar


 $7000.00 Seems like alot for a shaft. If it was $700.00 I might be
interested. Any chance off a sketch, as its hard to visualise.
Ian.


The shaft will not sell for $7000 each. What Tracy is talking about is the
investment
he must make to have them made in a reasonable cost effective quantity.
He must buy a bunch  of shaft forgings, modify the NC lathe program and
order a bunch from the NC machine shop so he can sell you a new shaft
or 2.85:1 psru at a reasonable cost.

Tracy is also talking about adapting his parts to the stock 2.85:1 planet
carrier rather than adapting the stock 2.85:1 planet carrier to his parts.
The advantage to you is it makes it very very cheap for all you guys to
overhaul one of Tracy's psru's. In other words overhaul parts are
available
over the counter from a Ford dealer's parts department.

Very commendable of Tracy. What I suggested was for Tracy to have the
planet carrier modified to fit his current shaft design but he wisely
rejected that idea as it would increase the cost of the over haul.
Is this about right Tracy?

Here is a picture of the part we are talking about. This is probably
one of the most expensive  parts in the PSRU.

Paul Lamar


Yes, Paul stated the situation exactly right.  Also true that the prop shaft
is the most expensive part in the drive.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com


The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org