Subject: using aluminum brazing/solding to tack weld before TIG welding?
From: ACRE NL
Date: 11/4/2001, 8:31 AM


 > A low temp brazing rod (e.g.. Aladdin) can have
a weld over it. The weld
will not
 > be of high strength and it is a pain in the ass
to do since some areas
will melt
 > at different temps. And temperature control is
the whole point in welding.
 >
 > I'd ask whomever was doing my welding if it was
ok on his end. But if I
didn't
 > have a TIG it is a definite option.
 > Blake

Forget it. The brazing stuff just spoils the weld.
Turns black ruins it.

Lynn E. Hanover

Going to have the same problem, not only with alum
but with steel parts i'm fabing. Wonder if epoxy might
work.  Stick it with the epoxy, have the welder tack
it then grind out epoxy.  Any ideas?  jim coffman

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org