Love to!!! Skip
Since it is a chassis dyno you will have to install it in a car
Ken. PL
WOW! This kind of changes things. The only problem is that I do not own a RX-7 - the previous one I owned I bought used and it was a pile of junk! I love the motor though. If we can figure something out I will go ahead and build the motor though. Skip, this will be a peripheral ported 13b using variable intake port timing and I will turn the engine up to 7400 rpm. The intake runners will be ~ 16" to 18" long and will be ground adjustable so the correct length can be identified. The exhaust will be 28" long before the collector. I am guessing / hoping for 220 HP (but wouldn't 230 or 240 HP be great). I will be using the same port timing as the Mazda Lemans engine. Cruise rpm will be 6000 rpm.
BTW Skip, where are you located. I am just outside of Little Rock, AR.
Ken P.
At 7400 RPM Ken you should get a lot more than 240 HP. I would say closer to 300 HP.
Jon Lauter of Rotary Power Marine is also installing an engine dyno. He has an interest
in this engine so he might allow you to test it on his dyno. No car required.
He is in NJ and Skip is in Idaho so it is a wash as far as distance is concerned I would
say.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org